5.0 out of 5 stars Works !

m. · May 19, 2025

(function() { P.when('cr-A', 'ready').execute(function(A) { if(typeof A.toggleExpanderAriaLabel === 'function') { A.toggleExpanderAriaLabel('review_text_read_more', 'Read more of this review', 'Read less of this review'); } }); })(); .review-text-read-more-expander:focus-visible { outline: 2px solid #2162a1; outline-offset: 2px; border-radius: 5px; } Works,just make sure to tighten in well enough

5.0 out of 5 stars Helpful when working in tight spaces.

R. · May 1, 2025

Very useful for product placement. Good quality.

5.0 out of 5 stars Great products

M.G. · April 2, 2025

Great connectivity great quality great value for the money perfect

5.0 out of 5 stars Works ok for 802.11 Test

N. · March 2, 2021

I used them for IC PHY level testing of 802.11g 54 Mbps and and 802.11nMCS-7 20 MHz BW tests. I needed to add 10 dB inline attenuators because the output signal is too high going into the RF digitizer causing compression. There isn't enough clearance under the boards so these SMA elbows work great. There isn't any specification of the Insertion Loss, BW or VSWR on these SMA elbows. However, I did measure the EVM of the IC and the results correlates well even without the SMA elbows inline to the RF Digitizer. Since EVM is composite measurement, it is safe to state the the match is good and the insertion loss is less than 1 dB.Mechanical wise, the male connector head turns freely. This is typical and preferred for my application so that if there is a tug on the RF cable, there will be some tolerance for it to turn such that it doesn't rip apart my USD 100+ SMP/SMA RF cables. I have a bunch of them per-board. If you desire a tight connection, then use a SMA torque tool. I have one of these tool and they can cost a few hundred dollars and you have to get them calibrated every year. I typically use this tool only when I do not want any play or movement when connecting up all the RF instrumentations. It may also help the gain by 0.1 dB, but that's very subjective. In most cases, my finger does all the torqueing.

4.0 out of 5 stars Works, no issues or signal loss.

T. · June 14, 2025

So far they work as intended to make connecting an antenna to the T-Mobile G4AR gateway easier and with less stress on the gateway connectors.I checked the signal metrics and they are the same with and without the connectors so minimum signal loss as well.Will update if anything changes.

5.0 out of 5 stars Work well

A. · December 1, 2024

Quality connectors that fit fine. Haven't noticed any signs of signal degradation. Takes the strain off of SMA connectors on gateway.

5.0 out of 5 stars Connectors for any contingency

J.W.G. · November 10, 2024

Durable connectors to be prepared tlfor any antenna cable connection

5.0 out of 5 stars Works on Eufy S330 4G LTE

M. · October 26, 2024

Works on Eufy s330 4G LTE wireless camera if you need an extender for an external antenna