5.0 out of 5 stars It works out of the box

z. · August 29, 2023

(function() { P.when('cr-A', 'ready').execute(function(A) { if(typeof A.toggleExpanderAriaLabel === 'function') { A.toggleExpanderAriaLabel('review_text_read_more', 'Read more of this review', 'Read less of this review'); } }); })(); .review-text-read-more-expander:focus-visible { outline: 2px solid #2162a1; outline-offset: 2px; border-radius: 5px; } Was very impressed with this carb and the quality. It worked straight out of the box with no adjustments needed. Idles perfectly . Only thing different that I noticed was the fuel inlet was at an angle and the OEM fuel hose was a little short. I replaced the hose anyway so no big deal. If you need hose you will want 5/16 ID x 1/2 OD

5.0 out of 5 stars Perfect right out of the box!

D.P. · October 11, 2022

I was a bit skeptical about an after market carb but I installed this thing quickly and the atv I put it in fired right up. No adjustments needed and has been perfectly functioning so far.

4.0 out of 5 stars It started

K. · March 21, 2022

The product shipped and delivered fairly quickly and was here in time to be installed over the weekend. The only downside to this is there aren’t any new hoses fitted with the carb so my old cracked ones had to be replaced as well. It was not advertised but I figured it would have come with new hoses along with a semi figurative instruction manual.. no biggie though. Overall it took about an hour to fit it up and get it running, didn’t even need to choke it. Seems to have zero issues thus far.

5.0 out of 5 stars Works better than new

C.L. · June 16, 2024

2002 Honda Rancher 350 with original carb was always a little finicky with the need for choke. Put this replacement on after the original sat for a very long time. Started straight up and runs better than new. For $30 compared to $300 for the OEM its unbeatable value.

5.0 out of 5 stars Direct fit

S. · March 15, 2024

Fit and worked right out of the box for a 1990 Honda 300

5.0 out of 5 stars Rapid delivery, exact fit

D.J.L.P. · May 3, 2021

This replacement carb fit perfectly. It had a carb heater attachment point as well. The "tune" for our Rancher 350 was right on. Only needed to adjust the idle, other jets set to perfect running mix. As with most of these parts, some explanations of how choke cable and throttle cables are installed would have been beneficial for a "first timer". You need to turn carb around and around to install throttle cable retaining nut....so nothing else can be attached. You find that out forthwith. Overall, an excellent product that was properly adjusted for our application....and very rapid delivery. A good value.

1.0 out of 5 stars Stuck float valve

H.C. · July 14, 2023

Fit right up with no problems, took it for a test drive and parked it. Only to come back to find all the gas had leaked out due to the float valve being stuck. The design for the float hinge is horrible. Would not recommend.

5.0 out of 5 stars Good as OEM

B.L. · September 10, 2021

Fit perfect very little adjusting needed and no choke to start! Purrs like a kitten

Super ! 👍

g. · March 25, 2025

(function() { P.when('cr-A', 'ready').execute(function(A) { if(typeof A.toggleExpanderAriaLabel === 'function') { A.toggleExpanderAriaLabel('review_text_read_more', 'Read more of this review', 'Read less of this review'); } }); })(); .review-text-read-more-expander:focus-visible { outline: 2px solid #2162a1; outline-offset: 2px; border-radius: 5px; } Fonctione parfaitement !L’arrivée d’essence est decalée de 90 degrée , pas de probleme si vous instaler une hose a gaz neuve !

Worked good but needed additional parts

P.N. · June 3, 2025

This says it’s fits a 89 300 Honda and it it does but required a lot of adjustments and had to purchase additional jets to get it right. Once I got it, it works just like OEM but took me a few times in and out to get it where it should be. Buy a pack of different sized jets when you go to do this job.

Delivery was quick

A.C. · April 28, 2024

Fit my husbands atv perfectly

Missing an inlet?

k. · September 9, 2024

Not installed yet as there's seems to be something missing here...has anyone experienced this?

It won’t run with the carb needle use your old one

D.B. · March 25, 2023

It was cheap